HD64F3048VTF8 Datasheet, PDF (236/903 Pages) Renesas Technology Corp – Hardware Manual Renesas 8-Bit Single-Chip

Section 8 DMA Controller
8.2.4 Data Transfer Control Registers (DTCR)
A data transfer control register (DTCR) is an 8-bit readable/writable register that controls the
operation of one DMAC channel.
Bit
Initial value
Read/Write
7
DTE
0
R/W
6
DTSZ
0
R/W
5
DTID
0
R/W
4
RPE
0
R/W
3
DTIE
0
R/W
2
DTS2
0
R/W
1
DTS1
0
R/W
0
DTS0
0
R/W
Data transfer enable
Enables or disables
data transfer
Data transfer select
These bits select the data
transfer activation source
Data transfer size
Selects byte or
word size
Data transfer interrupt enable
Enables or disables the CPU interrupt
at the end of the transfer
Data transfer
increment/decrement
Selects whether to
increment or decrement
the memory address
register
Repeat enable
Selects repeat
mode
The DTCRs are initialized to H'00 by a reset and in standby mode.
Bit 7—Data Transfer Enable (DTE): Enables or disables data transfer on a channel. When the
DTE bit is set to 1, the channel waits for a transfer to be requested, and executes the transfer when
activated as specified by bits DTS2 to DTS0. When DTE is 0, the channel is disabled and does not
accept transfer requests. DTE is set to 1 by reading the register when DTE is 0, then writing 1.
Bit 7: DTE
0
1
Description
Data transfer is disabled. In I/O mode or idle mode, DTE is cleared to 0 when
the specified number of transfers have been completed.
(Initial value)
Data transfer is enabled
If DTIE is set to 1, a CPU interrupt is requested when DTE is cleared to 0.
Rev. 3.00 Sep 27, 2006 page 208 of 872
REJ09B0325-0300