HD6417727BP160CV Datasheet, PDF (749/1098 Pages) Renesas Technology Corp – Renesas 32-Bit RISC Microcomputer SuperH™ RISC engine Family/ SH7700 Series

Section 23 USB Function Controller
Section 23 USB Function Controller
23.1 Features
• Incorporates UDC (USB device controller) conforming to USB1.1
Automatic processing of USB protocol
Automatic processing of USB standard commands for endpoint 0 (some commands and
class/vendor commands require decoding and processing by firmware)
• Transfer speed: Full-speed
• Endpoint configuration
Endpoint
Name
Endpoint 0
Endpoint 1
Endpoint 2
Endpoint 3
Abbreviation
EP0s
EP0i
EP0o
EP1
EP2
EP3
Transfer Type
Setup
Control-in
Control-out
Bulk-out
Bulk-in
Interrupt
Maximum
Packet Size
8
8
8
64
64
8
FIFO Buffer
Capacity
8
8
8
128
128
8
DMA Transfer
—
—
—
Possible
Possible
—
Configuration 1 — Interface 0 — Alternate setting 0
End point 1
End point 2
End point 3
• Interrupt requests: generates various interrupt signals necessary for USB
transmission/reception
• Clock: Selection by means of EXCPG
For details, see section 11, Extend Clock Pulse Generator for USB (EXCPG).
• Power-down mode
Power consumption can be reduced by stopping internal clock when UDC cable is
disconnected
Automatic transition to/recovery from suspend state
• Can be connected to a Philips PDIUSBP11 Series transceiver or compatible product (when
using a compatible product, carry out evaluation and investigation with the manufacturer
supplying the transceiver beforehand)
• This USB function controller is a self-power device. It cannot operate by power supplied from
the USB cable.
Rev.6.00 Mar. 27, 2009 Page 691 of 1036
REJ09B0254-0600