TCI6636K2H Datasheet, PDF (268/362 Pages) Texas Instruments – Multicore DSP+ARM KeyStone II System-on-Chip (SoC)

TCI6636K2H
Multicore DSP+ARM KeyStone II System-on-Chip (SoC)
SPRS835F—October 2013
9.3 Electrical Characteristics
Table 9-3
Electrical Characteristics
Over Recommended Ranges of Supply Voltage and Operating Case Temperature (Unless Otherwise Noted)
Parameter
Test Conditions ⁽¹⁾
Min
Typ Max Unit
V_OH ⁽²⁾ High-level output voltage
LVCMOS (1.8 V)
DDR3A, DDR3B
I²C ⁽³⁾
I_O = I_OH
DVDD18 - 0.45
DVDD15 - 0.4
V
(3)
V
(2)
OL
Low-level output voltage
I_I ⁽⁴⁾ Input current [DC]
LVCMOS (1.8 V)
DDR3A, DDR3B
I²C
LVCMOS (1.8 V)
I_O = I_OL
I_O = 3 mA, pulled up to 1.8 V
No IPD/IPU
Internal pullup
Internal pulldown
0.45
0.4 V
0.4
-10
10
50
100
170 μA
-170 -100
-50
I²C
0.1 × DVDD18 V < V_I < 0.9 ×
-10
10 μA
DVDD18 V
LVCMOS (1.8 V)
-6
I_OH High-level output current [DC] DDR3A, DDR3B
I²C ⁽⁵⁾
-8 mA
(5)
LVCMOS (1.8 V)
6
I_OL Low-level output current [DC] DDR3A, DDR3B
I²C
8 mA
3
I_OZ ⁽⁶⁾ Off-state output current [DC]
End of Table 9-3
LVCMOS (1.8 V)
DDR3A, DDR3B
I²C
-10
10
-10
10 μA
-10
10
1 For test conditions shown as MIN, MAX, or TYP, use the appropriate value specified in the recommended operating conditions table.
2 For USB High-Speed, Full-Speed, and Low -Speed modes, USB I/Os adhere to Universal Serial Bus, revision 2.0 standard. For USB Super-Speed mode, USB I/Os adhere to
Universal Serial Bus, revision 3.1 specification, revision 1.0 standard.
3 I²C uses open collector IOs and does not have a V_OH Minimum.
4 I_I applies to input-only pins and bidirectional pins. For input-only pins, I_I indicates the input leakage current. For bidirectional pins, I_I includes input leakage current and
off-state (Hi-Z) output leakage current.
5 I²C uses open collector IOs and does not have a I_OH Maximum.
6 I_OZ applies to output-only pins, indicating off-state (Hi-Z) output leakage current.
268 Device Operating Conditions
Copyright 2013 Texas Instruments Incorporated
Submit Documentation Feedback