HD6417705F133V Datasheet, PDF (526/741 Pages) Renesas Technology Corp – Renesas 32-Bit RISC Microcomputer SuperH RISC engine Family/SH7700 Series

Port Port Function (Related Module)
Other Functions (Related Module)
N
PTN7 input/output (port)

N
PTN6 input/output (port)
DPLS input (USB)
N
PTN5 input/output (port)
DMNS input (USB)
N
PTN4 input/output (port)
TXDPLS output (USB)
N
PTN3 input/output (port)
TXDMNS output (USB)
N
PTN2 input/output (port)
XVDATA input (USB)
N
PTN1 input/output (port)
TXENL output (USB)
N
SCPT
SCPT
PTN0 input/output (port)
SCPT5 input/output (port)
SCPT4 input/output (port)
SUSPND output (USB)
CTS2 input (SCIF2)
RTS2 output (SCIF2)
SCPT
SCPT
SCPT
SCPT3 input/output (port)
SCPT2 input (port)^*2
SCPT2 output (port)^*2
SCK2 input/output (SCIF2)
RXD2 input (SCIF2)
TXD2 output (SCIF2)
SCPT
SCPT
SCPT
SCPT1 input/output (port)
SCPT0 input (port)^*2
SCPT0 output (port)^*2
SCK0 input/output (SCIF0)
RXD0 input (SCIF0)/IrRX input (IrDA)
TXD0 output (SCIF0)/IrTX output (IrDA)
Notes: 1. The initial functions of NF (No Function) pins are not assigned after power-on reset.
Specifies the functions with Pin Function Controller (PFC).
PTD5 and PTM4 must be pulled up.
PTJ[7:0] must be open except for the pins specified as port output pins.
The values of PTJ6, PTJ1, and PTJ0 differ during power-on reset and after the power-
on reset state is released. They conform to the port J data register value after being
switched to port status by the pin function controller (PFC).
After Power-On Reset Release
During Power-On Reset PTD5/NF = 1
PTD5/NF = 0
PTJ6/NF
1
PTJ1/NF
1
PTJ0/NF
1
0
1
1
0
0
1
2. SCPT0 and SCPT2 each have two separate pins for input and output, however, a
common data register is accessed.
In table 19.1, pin functions in the shaded column can be used immediately after a power-on reset.
Rev. 2.00, 09/03, page 478 of 690