SH7710 Datasheet, PDF (226/996 Pages) Renesas Technology Corp – Renesas 32-Bit RISC Microcomputer SuperHTM RISC engine Family / SH7700 Series

Section 5 Memory Management Unit (MMU)
1. P0, P3, and U0 Areas
The P0, P3, and U0 areas can be address translated by the TLB and can be accessed through
the cache. If the MMU is enabled, these areas can be mapped to any physical address space in
1- or 4-kbyte page units via the TLB. If the CE bit in the cache control register (CCR1) is set
to 1 and if the corresponding cache enable bit (C bit) of the TLB entry is set to 1, access via the
cache is enabled. If the MMU is disabled, replacing the upper three bits of an address in these
areas with 0s creates the address in the corresponding physical address space. If the CE bit of
the CCR1 register is set to 1, access via the cache is enabled. When the cache is used, either
the copy-back or write-through mode is selected for write access via the WT bit in CCR1.
If these areas are mapped to the on-chip module control register area or on-chip memory area
in area 1 in the physical address space via the TLB, the C bit of the corresponding page must
be cleared to 0.
2. P1 Area
The P1 area can be accessed via the cache and cannot be address-translated by the TLB.
Whether the MMU is enabled or not, replacing the upper three bits of an address in these areas
with 0s creates the address in the corresponding physical address space. Use of the cache is
determined by the CE bit in the cache control register (CCR1). When the cache is used, either
the copy-back or write-through mode is selected for write access by the CB bit in the CCR1
register.
3. P2 Area
The P2 area cannot be accessed via the cache and cannot be address-translated by the TLB.
Whether the MMU is enabled or not, replacing the upper three bits of an address in this area
with 0s creates the address in the corresponding physical address space.
4. P4 Area
The P4 area is mapped to the on-chip I/O of this LSI. This area cannot be accessed via the
cache and cannot be address-translated by the TLB. Figure 5.4 shows the configuration of the
P4 area.
Rev. 2.00 Dec. 07, 2005 Page 184 of 950
REJ09B0079-0200