SH7144 Datasheet, PDF (342/773 Pages) Renesas Technology Corp – Hitachi SuperH RISC engine

TGRA_3
TCDR
TCNT_3
TCNT_4
TDDR
H'0000
Complementary PWM
mode operation
Complementary PWM
mode operation
Counter
Complementary
operation stop PMW restart
Figure 11.80 Counter Value during Complementary PWM Mode Stop
11.7.13 Buffer Operation Setting in Complementary PWM Mode
In complementary PWM mode, conduct rewrites by buffer operation for the PWM cycle setting
register (TGRA_3), timer cycle data register (TCDR), and duty setting registers (TGRB_3,
TGRA_4, and TGRB_4).
In complementary PWM mode, channel 3 and channel 4 buffers operate in accordance with bit
settings BFA and BFB of TMDR_3. When TMDR_3’s BFA bit is set to 1, TGRC_3 functions as a
buffer register for TGRA_3. At the same time, TGRC_4 functions as the buffer register for
TGRA_4, while the TCBR functions as the TCDR’s buffer register.
11.7.14 Reset Sync PWM Mode Buffer Operation and Compare Match Flag
When setting buffer operation for reset sync PWM mode, set the BFA and BFB bits of TMDR_4
to 0. The TIOC4C pin will be unable to produce its waveform output if the BFA bit of TMDR_4 is
set to 1.
In reset sync PWM mode, the channel 3 and channel 4 buffers operate in accordance with the BFA
and BFB bit settings of TMDR_3. For example, if the BFA bit of TMDR_3 is set to 1, TGRC_3
functions as the buffer register for TGRA_3. At the same time, TGRC_4 functions as the buffer
register for TGRA_4.
The TGFC bit and TGFD bit of TSR_3 and TSR_4 are not set when TGRC_3 and TGRD_3 are
operating as buffer registers.
Rev. 2.0, 09/02, page 302 of 732