82801BA Datasheet, PDF (91/498 Pages) Intel Corporation – Intel 82801BA I/O Controller Hub 2 (ICH2) and Intel 82801BAM I/O Controller Hub 2 Mobile

Functional Description
5.4.5
Software Commands
There are three additional special software commands that the DMA controller can execute. The
three software commands are:
• Clear Byte Pointer Flip-Flop
• Master Clear
• Clear Mask Register
They do not depend on any specific bit pattern on the data bus.
Clear Byte Pointer Flip-Flop
This command is executed prior to writing or reading new address or word count information
to/from the DMA controller. This initializes the flip-flop to a known state so that subsequent
accesses to register contents by the processor addresses upper and lower bytes in the correct
sequence.
When the Host processor is reading or writing DMA registers, two Byte Pointer flip-flops are used;
one for channels 0–3 and one for channels 4–7. Both of these act independently. There are separate
software commands for clearing each of them (0Ch for channels 0–3, 0D8h for channels 4–7).
DMA Master Clear
This software instruction has the same effect as the hardware reset. The Command, Status,
Request, and Internal First/Last Flip-Flop Registers are cleared and the Mask Register is set. The
DMA controller enters the idle cycle.
There are two independent master clear commands; 0Dh acts on channels 0–3, and 0DAh acts on
channels 4–7.
Clear Mask Register
This command clears the mask bits of all four channels, enabling them to accept DMA requests.
I/O port 00Eh is used for channels 0–3 and I/O port 0DCh is used for channels 4–7.
82801BA ICH2 and 82801BAM ICH2-M Datasheet
5-29