82801BA Datasheet, PDF (412/498 Pages) Intel Corporation – Intel 82801BA I/O Controller Hub 2 (ICH2) and Intel 82801BAM I/O Controller Hub 2 Mobile

AC’97 Modem Controller Registers (D31:F6)
14.1.2
14.1.3
DID—Device Identification Register (Modem—D31:F6)
Address Offset:
Default Value:
Lockable:
03h–02h
2446h
No
Attribute:
Size:
Power Well:
RO
16 Bits
Core
Bit
15:0
Device ID Value.
Description
PCICMD—PCI Command Register (Modem—D31:F6)
Address Offset:
Default Value:
Lockable:
05h–04h
0000h
No
Attribute:
Size:
Power Well:
R/W
16 bits
Core
PCICMD is a 16-bit control register. Refer to the PCI 2.1 specification for complete details on each
bit.
Bit
15:10
9
8
7
6
5
4
3
2
1
0
Description
Reserved. Read 0.
Fast Back to Back Enable (FBE). Not implemented. Hardwired to 0.
SERR# Enable (SEN). Not implemented. Hardwired to 0.
Wait Cycle Control (WCC). Not implemented. Hardwired to 0.
Parity Error Response (PER). Not implemented. Hardwired to 0.
VGA Palette Snoop (VPS). Not implemented. Hardwired to 0.
Memory Write and Invalidate Enable (MWI). Not implemented. Hardwired to 0.
Special Cycle Enable (SCE). Not implemented. Hardwired to 0.
Bus Master Enable (BME)—R/W. Controls standard PCI bus mastering capabilities.
0 = Disable.
1 = Enable
Memory Space (MS). Hardwired to 0, AC ‘97 does not respond to memory accesses.
I/O Space (IOS)—R/W. This bit controls access to the I/O space registers.
0 = Disable access. (default = 0).
1 = Enable access to I/O space. The Native PCI Mode Base Address register should be
programmed prior to setting this bit.
14-2
82801BA ICH2 and 82801BAM ICH2-M Datasheet