C8051F970-A-GM Datasheet, PDF (169/454 Pages) Silicon Laboratories – Low Power Capacitive Sensing MCU with up to 32 kB of Flash

C8051F97x
Notes on Registers, Operands and Addressing Modes:
Rn—Register R0–R7 of the currently selected register bank.
@Ri—Data RAM location addressed indirectly through R0 or R1.
rel—8-bit, signed (twos complement) offset relative to the first byte of the following instruction. Used by SJMP
and all conditional jumps.
direct—8-bit internal data location’s address. This could be a direct-access Data RAM location (0x00–0x7F) or
an SFR (0x80–0xFF).
#data—8-bit constant
#data16—16-bit constant
bit—Direct-accessed bit in Data RAM or SFR
addr11—11-bit destination address used by ACALL and AJMP. The destination must be within the same 2 kB
page of program memory as the first byte of the following instruction.
addr16—16-bit destination address used by LCALL and LJMP. The destination may be anywhere within the
8 kB program memory space.
There is one unused opcode (0xA5) that performs the same function as NOP.
All mnemonics copyrighted © Intel Corporation 1980.
170
Rev 1.0