MMC2107 Datasheet, PDF (95/618 Pages) –

Freescale Semiconductor, Inc.
Chip Configuration Module (CCM)
Memory Map and Registers
LOAD — Pad Driver Load Bit
The LOAD bit selects full or default drive strength for selected pad
output drivers. For maximum capacitive load, set the LOAD bit to
select full drive strength. For reduced power consumption, clear the
LOAD bit to select default drive strength.
1 = Full drive strength
0 = Default drive strength
Table 3-2 shows the read/write accessibility of this write-once bit.
SHEN — Show Cycle Enable Bit
The SHEN bit enables the external memory interface to drive the
external bus during internal transfer operations.
1 = Show cycles enabled
0 = Show cycles disabled
In emulation mode, the SHEN bit is read-only. In all other modes, it is
a read/write bit.
EMINT — Emulate Internal Address Space Bit
The EMINT bit enables chip select 1 (CS1) to decode the internal
memory address space.
1 = CS1 decodes internal memory address space.
0 = CS1 decodes external memory address space.
The EMINT bit is read-always but can be written only in emulation
mode.
MODE[2:0] — Chip Configuration Mode Field
This read-only field reflects the chip configuration mode, as shown in
Table 3-4.
Table 3-4. Chip Configuration Mode Selection
MODE[2:0]
111
110
10X
0XX
Chip Configuration Mode
Master mode
Single-chip mode
FAST mode
Emulation mode
MMC2107 – Rev. 2.0
MOTOROLA
Chip Configuration Module (CCM)
For More Information On This Product,
Go to: www.freescale.com
Technical Data
95