MMC2107 Datasheet, PDF (430/618 Pages) –

Freescale Semiconductor, Inc.
Queued Analog-to-Digital Converter (QADC)
CF2 — Queue 2 Completion Flag
CF2 indicates that a queue 2 scan has been completed. CF2 is set by
the QADC when the input channel sample requested by the last CCW
in queue 2 is converted, and the result is stored in the result table.
The end-of-queue 2 is identified when the current CCW contains an
end-of-queue code instead of a valid channel number or when the
currently completed CCW is in the last location of the CCW RAM.
When CF2 is set and interrupts are enabled for that queue completion
flag, the QADC asserts an interrupt request. The software reads CF2
during an interrupt service routine to identify the interrupt request. The
interrupt request is cleared when the software writes a 0 to the CF2
bit, when the bit was previously read as a 1. Once set, only software
or reset can clear CF2.
CF2 is maintained by the QADC regardless of whether the
corresponding interrupts are enabled. The software polls for CF2 to
see if it is set. This allows the software to recognize that the QADC is
finished with a queue 2 scan. The software acknowledges that it has
detected the completion flag being set by writing a 0 to the completion
flag after the bit was read as a 1.
PF2 — Queue 2 Pause Flag
PF2 indicates that a queue 2 scan has reached a pause. PF2 is set
by the QADC when the current queue 2 CCW has the pause bit set,
the selected input channel has been converted, and the result has
been stored in the result table.
Once PF2 is set, the queue enters the paused state and waits for a
trigger event to allow queue execution to continue. However, if the
CCW with the pause bit set is the last CCW in a queue, the queue
execution is complete. The queue status becomes idle, not paused,
and both the pause and completion flags are set. Another exception
occurs in software controlled mode, where the PF2 can be set but
queue 2 never enters the pause state.
When PF2 is set and interrupts are enabled for the corresponding
queue, the QADC asserts an interrupt request. The software reads
PF2 during an interrupt service routine to identify the interrupt
request. The interrupt request is cleared when the software writes a 0
to PF2, when the bit was previously read as a 1. Once set, only
software or reset can clear PF2.
Technical Data
430
Queued Analog-to-Digital Converter (QADC)
For More Information On This Product,
Go to: www.freescale.com
MMC2107 – Rev. 2.0
MOTOROLA