MMC2107 Datasheet, PDF (377/618 Pages) –

Freescale Semiconductor, Inc.
Serial Peripheral Interface Module (SPI)
Memory Map and Registers
MSTR — Master Bit
The MSTR bit selects SPI master mode or SPI slave mode operation.
Reset clears MSTR.
1 = Master mode
0 = Slave mode
CPOL — Clock Polarity Bit
The CPOL bit selects an inverted or non-inverted SPI clock. To
transmit data between SPI modules, the SPI modules must have
identical CPOL values. Reset clears CPOL.
1 = Active-low clock; SCK idles high
0 = Active-high clock; SCK idles low
CPHA — Clock Phase Bit
The CPHA bit delays the first edge of the SCK clock. Reset sets
CPHA.
1 = First SCK edge at start of transmission
0 = First SCK edge 1/2 cycle after start of transmission
SSOE — Slave Select Output Enable Bit
The SSOE bit and the DDRSP3 bit configure the SS pin as a
general-purpose input or a slave-select output. Reset clears SSOE.
Table 17-3. SS Pin I/O Configurations
DDRSP3 SSOE
Master Mode
0
0 Mode-fault input
0
1 General-purpose input
1
0 General-purpose output
1
1 Slave-select output
Slave Mode
Slave-select input
Slave-select input
Slave-select input
Slave-select input
NOTE: Setting the SSOE bit disables the mode fault detect function.
LSBFE — LSB-First Enable Bit
The LSBFE enables data to be transmitted LSB first. Reset clears
LSBFE.
1 = Data transmitted LSB first.
0 = Data transmitted MSB first
NOTE: In SPIDR, the MSB is always bit 7 regardless of the LSBFE bit.
MMC2107 – Rev. 2.0
MOTOROLA
Serial Peripheral Interface Module (SPI)
For More Information On This Product,
Go to: www.freescale.com
Technical Data
377