MMC2107 Datasheet, PDF (194/618 Pages) –

Freescale Semiconductor, Inc.
Non-Volatile Memory FLASH (CMFR)
NVR — Negative Voltage Range Select Bit
The read-always NVR bit modulates the negative pump output to
select the negative voltage range in program and erase modes as
shown in Table 9-2. NVR is writable when the HVS bit is clear but has
no effect when the GDB bit is clear.
1 = Negative voltage low range
0 = Negative voltage high range
Table 9-2. Negative Voltage Modulation
PAWS[2:0]
NVR = 0
NVR = 1
100
–6 V
–2 V
101
–7 V
–3 V
110
–8 V
–4 V
111
–9 V
–5 V
0XX
Reserved⁽¹⁾
1. When PAWS[2] = 0 and PAWS[1:0] have no effect.
PAWS[2:0] — Pulse Amplitude/Width Select Field
The read-always PAWS[2:0] field selects the pulse drain amplitude
and width for program or erase operations. PAWS[2:0] is writable
when the HVS bit is clear. PAWS[2] must be set for all program and
erase operations. If GDB = 1, the gate/source voltage applied during
program/erase is determined by PAWS[1:0] and NVR and shown in
Table 9-2.
NOTE:
The program pulse time is equal to the value selected by the pulse width
timing control. When SES = 1, write to SCLKR[2:0], CLKPE[1:0], and
CLKPM[6:0] only when PAWS[2] = 1. Do not write to PAWS[2:0] during
high-voltage operations.
RSVD6 — Reserved
Reserved for factory test and must remain clear at all times
Technical Data
194
Non-Volatile Memory FLASH (CMFR)
For More Information On This Product,
Go to: www.freescale.com
MMC2107 – Rev. 2.0
MOTOROLA