MMC2107 Datasheet, PDF (287/618 Pages) –

Freescale Semiconductor, Inc.
Programmable Interrupt Timer Modules (PIT1 and PIT2)
Memory Map and Registers
OVW — Overwrite Bit
The read/write OVW bit enables writing to PMR to immediately
overwrite the value in the PIT counter.
1 = Writing PMR immediately replaces value in PIT counter.
0 = Value in PMR replaces value in PIT counter when count
reaches 0x0000.
PIE — PIT Interrupt Enable Bit
The read/write PIE bit enables the PIF flag to generate interrupt
requests.
1 = PIF interrupt requests enabled
0 = PIF interrupt requests disabled
PIF — PIT Interrupt Flag
The read/write PIF flag is set when the PIT counter reaches 0x0000.
Clear PIF by writing a 1 to it or by writing to PMR. Writing 0 has no
effect. Reset clears PIF.
1 = PIT count has reached 0x0000.
0 = PIT count has not reached 0x0000.
RLD — Reload Bit
The read/write RLD bit enables loading the value of PMR into the PIT
counter when the count reaches 0x0000.
1 = Counter reloaded from PMR on count of 0x0000
0 = Counter rolls over to 0xFFFF on count of 0x0000
EN — PIT Enable Bit
The read/write EN bit enables PIT operation. When the PIT is
disabled, the counter and prescaler are held in a stopped state.
1 = PIT enabled
0 = PIT disabled
MMC2107 – Rev. 2.0
MOTOROLA
Programmable Interrupt Timer Modules (PIT1 and PIT2)
For More Information On This Product,
Go to: www.freescale.com
Technical Data
287