HD64F3039F18 Datasheet, PDF (702/710 Pages) Renesas Technology Corp – Renesas 16-Bit Single-Chip Microcomputer H8 Family / H8/300H Series

Appendix D Pin States
Reset in T3 State
Figure D.3 is a timing diagram for the case in which RES goes low during the T₃ state of an
external memory access cycle. As soon as RES goes low, all ports are initialized to the input state.
AS, RD, and WR go high, and the data bus goes to the high-impedance state. The address bus
outputs are held during the T₃ state.The same timing applies when a reset occurs in the T₂ state of
an access cycle to a two-state-access area.
Access to external address
T₁
T₂
T₃
φ
RES
Internal
reset signal
Address bus
(modes 1, 3, 5)
AS (modes 1, 3, 5)
H'000000
RD (read access)
(modes 1, 3, 5)
WR (write access)
(modes 1, 3, 5)
Data bus
(write access)
(modes 1, 3, 5)
I/O port
(modes 1, 3, 5 to 7)
High impedance
High impedance
Figure D.3 Reset during Memory Access (Reset during T3 State)
Rev.3.00 Mar. 26, 2007 Page 678 of 682
REJ09B0353-0300