HD64F3039F18 Datasheet, PDF (336/710 Pages) Renesas Technology Corp – Renesas 16-Bit Single-Chip Microcomputer H8 Family / H8/300H Series

Section 9 Programmable Timing Pattern Controller
9.3.4 Non-Overlapping TPC Output
Sample Setup Procedure for Non-Overlapping TPC Output
Figure 9.6 shows a sample procedure for setting up non-overlapping TPC output.
ITU setup
Port and
TPC setup
ITU setup
Non-overlapping
TPC output
Select GR functions
1
Set GR values
2
Select counting operation
3
Select interrupt requests
4
Set initial output data
5
Set up TPC output
6
Enable TPC transfer
7
Select TPC transfer trigger
8
Select non-overlapping groups 9
Set next TPC output data
10
Start counter
11
1. Set TIOR to make GRA and GRB output
compare registers (with output inhibited).
2. Set the TPC output trigger period in GRB
and the non-overlap margin in GRA.
3. Select the counter clock source with bits
TPSC2 to TPSC0 in TCR. Select the counter
clear source with bits CCLR1 and CCLR0.
4. Enable the IMFA interrupt in TIER.
5. Set the initial output values in the DR bits
of the input/output port pins to be used for
TPC output.
6. Set the DDR bits of the input/output port pins
to be used for TPC output to 1.
7. Set the NDER bits of the pins to be used for
TPC output to 1.
8. In TPCR, select the ITU compare match
event to be used as the TPC output trigger.
9. In TPMR, select the groups that will operate
in non-overlap mode.
10. Set the next TPC output values in the NDR
bits.
11. Set the STR bit to 1 in TSTR to start the timer
counter.
12. At each IMFA interrupt, write the next output
value in the NDR bits.
No
Compare match A?
Yes
Set next TPC output data
12
Figure 9.6 Setup Procedure for Non-Overlapping TPC Output (Example)
Rev.3.00 Mar. 26, 2007 Page 312 of 682
REJ09B0353-0300