English
Language : 

HD64F3039F18 Datasheet, PDF (164/710 Pages) Renesas Technology Corp – Renesas 16-Bit Single-Chip Microcomputer H8 Family / H8/300H Series
Section 7 I/O Ports
7.2.3 Pin Functions in Each Mode
The pin functions of port 1 differ between mode 1, 3 (expanded mode with on-chip ROM
disabled), mode 5 (expanded mode with on-chip ROM enabled), mode 6, and 7 (single-chip
mode). The pin functions in each mode are described as follows.
Modes 1 and 3
Address output can be selected for each pin in port 1. Figure 7.2 shows the pin functions in modes
1 and 3.
Port 1
A7 (output)
A6 (output)
A5 (output)
A4 (output)
A3 (output)
A2 (output)
A1 (output)
A0 (output)
Figure 7.2 Pin Functions in Modes 1 and 3 (Port 1)
Mode 5
Address output or generic input can be selected for each pin in port 1. A pin becomes an address
output pin if the corresponding P1DDR bit is set to 1, and a generic input pin if this bit is cleared
to 0. Following a reset, all pins are input pins. To use a pin for address output, its P1DDR bit must
be set to 1. Figure 7.3 shows the pin functions in mode 5.
Rev.3.00 Mar. 26, 2007 Page 140 of 682
REJ09B0353-0300