HD64F3039F18 Datasheet, PDF (390/710 Pages) Renesas Technology Corp – Renesas 16-Bit Single-Chip Microcomputer H8 Family / H8/300H Series

Section 11 Serial Communication Interface
Receiving Serial Data (Asynchronous Mode): Figure 11.7 shows a sample flowchart for
receiving serial data and indicates the procedure to follow.
Initialize
1
Start receiving
Read ORER, PER,
and FER flags in SSR
2
PER ∨ FER ∨
Yes
ORER = 1?
3
No
Error handling
(continued on next page)
Read RDRF flag in SSR 4
No
RDRF = 1?
1. SCI initialization: the receive data function of
the RxD pin is selected automatically.
2., 3. Receive error handling and break
detection: if a receive error occurs, read the
ORER, PER, and FER flags in SSR to identify
the error. After executing the necessary error
handling, clear the ORER, PER, and FER
flags all to 0. Receiving cannot resume if any
of the ORER, PER, and FER flags remains
set to 1. When a framing error occurs, the
RxD pin can be read to detect the break state.
4. SCI status check and receive data read: read
SSR, check that RDRF is set to 1, then read
receive data from RDR and clear the RDRF
flag to 0. Notification that the RDRF flag has
changed from 0 to 1 can also be given by the
RXI interrupt.
5. To continue receiving serial data: check the
RDRF flag, read RDR, and clear the RDRF
flag to 0 before the stop bit of the current
frame is received.
Yes
Read receive data
from RDR, and clear
RDRF flag to 0 in SSR
No
Finished
receiving?
5
Yes
Clear RE bit to 0 in SCR
End
Figure 11.7 Sample Flowchart for Receiving Serial Data (1)
Rev.3.00 Mar. 26, 2007 Page 366 of 682
REJ09B0353-0300