HD64F3039F18 Datasheet, PDF (537/710 Pages) Renesas Technology Corp – Renesas 16-Bit Single-Chip Microcomputer H8 Family / H8/300H Series

17.3 Sleep Mode
Section 17 Power-Down State
17.3.1 Transition to Sleep Mode
When the SSBY bit is cleared to 0 in the system control register (SYSCR), execution of the
SLEEP instruction causes a transition from the program execution state to sleep mode.
Immediately after executing the SLEEP instruction the CPU halts, but the contents of its internal
registers are retained. The on-chip supporting modules do not halt in sleep mode. On-chip
supporting modules which have been placed in standby by the module standby function, however,
remain halted.
17.3.2 Exit from Sleep Mode
Sleep mode is exited by an interrupt, or by input at the RES or STBY pin.
Exit by Interrupt: An interrupt terminates sleep mode and causes a transition to the interrupt
exception handling state. Sleep mode is not exited by an interrupt source in an on-chip supporting
module if the interrupt is disabled in the on-chip supporting module. Sleep mode is not exited by
an interrupt other then NMI if the interrupt is masked by interrupt priority settings (IPR) and the
settings of the I and UI bits in CCR.
Exit by RES Input: Low input at the RES pin exits from sleep mode to the reset state.
Exit by STBY Input: Low input at the STBY pin exits from sleep mode to hardware standby
mode.
Rev.3.00 Mar. 26, 2007 Page 513 of 682
REJ09B0353-0300