English
Language : 

HD6413007F20 Datasheet, PDF (540/798 Pages) Renesas Technology Corp – Hardware Manual Renesas 16-Bit Single-Chip Microcomputer H8 Family/H8/300H Series
14. Smart Card Interface
D: Clock duty cycle (D = 0 to 1.0)
L: Frame length (L =10)
F: Absolute deviation of clock frequency
From the above equation, if F = 0 and D = 0.5, the receive margin is as follows.
When D = 0.5 and F = 0:
M = (0.5 − 1/2 × 372) × 100%
= 49.866%
Retransmission: Retransmission is performed by the SCI in receive mode and transmit mode as
described below.
• Retransmission when SCI is in Receive Mode
Figure 14.12 illustrates retransmission when the SCI is in receive mode.
1. If an error is found when the received parity bit is checked, the PER bit is automatically set to
1. If the RIE bit in SCR is set to the enable state, an ERI interrupt is requested. The PER bit
should be cleared to 0 in SSR before the next parity bit sampling timing.
2. The RDRF bit in SSR is not set for the frame in which the error has occurred.
3. If no error is found when the received parity bit is checked, the PER bit is not set to 1 in SSR.
4. If no error is found when the received parity bit is checked, the receive operation is assumed to
have been completed normally, and the RDRF bit is automatically set to 1 in SSR. If the RIE
bit in SCR is set to the enable state, an RXI interrupt is requested. If RXI is enabled as a DMA
transfer activation source, the RDR contents can be read automatically. When the DMAC
reads the RDR data, the RDRF flag is automatically cleared to 0.
5. When a normal frame is received, the data pin is held in the high-impedance state at the error
signal transmission timing.
Frame n
Ds D0 D1 D2 D3 D4 D5 D6 D7 Dp DE
Retransmitted frame
Frame n+1
(DE)
Ds D0 D1 D2 D3 D4 D5 D6 D7 Dp Ds D0 D1 D2 D3 D4
RDRF
[2]
[4]
PER
[1]
[3]
Figure 14.12 Retransmission in SCI Receive Mode
Rev.5.00 Sep. 12, 2007 Page 510 of 764
REJ09B0396-0500