HD6413007F20 Datasheet, PDF (511/798 Pages) Renesas Technology Corp – Hardware Manual Renesas 16-Bit Single-Chip Microcomputer H8 Family/H8/300H Series

13. Serial Communication Interface
13.4 SCI Interrupts
The SCI has four interrupt request sources: transmit-end interrupt (TEI), receive-error (ERI),
receive-data-full (RXI), and transmit-data-empty interrupt (TXI). Table 13.12 lists the interrupt
sources and indicates their priority. These interrupts can be enabled or disabled by the TIE, RIE,
and TEIE bits in SCR. Each interrupt request is sent separately to the interrupt controller.
A TXI interrupt is requested when the TDRE flag is set to 1 in SSR. A TEI interrupt is requested
when the TEND flag is set to 1 in SSR. A TXI interrupt request can activate the DMAC to transfer
data. Data transfer by the DMAC automatically clears the TDRE flag to 0. A TEI interrupt request
cannot activate the DMAC.
An RXI interrupt is requested when the RDRF flag is set to 1 in SSR. An ERI interrupt is
requested when the ORER, PER, or FER flag is set to 1 in SSR. An RXI interrupt can activate the
DMAC to transfer data. Data transfer by the DMAC automatically clears the RDRF flag to 0. An
ERI interrupt request cannot activate the DMAC.
The DMAC can be activated by interrupts from SCI channel 0.
Table 13.12 SCI Interrupt Sources
Interrupt Source
ERI
RXI
TXI
TEI
Description
Receive error (ORER, FER, or PER)
Receive data register full (RDRF)
Transmit data register empty (TDRE)
Transmit end (TEND)
Priority
High
Low
Rev.5.00 Sep. 12, 2007 Page 481 of 764
REJ09B0396-0500