MC9S12T64 Datasheet, PDF (568/608 Pages) Motorola, Inc – Specification

Freescale Semiconductor, Inc.
Electrical Characteristics
1. Maximum leakage current occurs at maximum operating temperature. Current decreases by approximately one-half for
each 8 C to 12 C in the temperature range from 50˚C to 125˚C.
2. Refer to the subsection Current Injection (page 563), for more details
Supply Currents
Measurement
Conditions
Additional
Remarks
This section describes the current consumption characteristics of the
device as well as the conditions for the measurements.
All measurements are without output loads. Unless otherwise noted the
currents are measured in single chip mode, internal voltage regulator
enabled and at 16MHz bus frequency using a 4MHz oscillator in Colpitts
mode. Production testing is performed using a square wave signal at the
EXTAL input.
In expanded modes the currents flowing in the system are highly
dependent on the load at the address, data and control signals as well
as on the duty cycle of those signals. No generally applicable numbers
can be given. A very good estimate is to take the single chip currents and
add the currents due to the external loads.
Table 109 Supply Current Characteristics
Conditions are shown in Table 106 unless otherwise noted
Num
Rating
Symbol Min
1
Run supply currents
Single Chip Mode I_DD5
Wait Supply current
2
All modules enabled, PLL on I_DDW
Only RTI enabled, PLL off
Pseudo Stop Current ⁽¹⁾
3
RTI and COP enabled I_DDPS
RTI and COP disabled
4 Stop Current
1. PLL off
I_DDS
Typ
Max Unit
30
mA
25
mA
10
500
7,000 µA
250 6,500
60
6,000 µA
MC9S12T64Revision 1.1.1
Electrical Characteristics
For More Information On This Product,
Go to: www.freescale.com