HD6432633 Datasheet, PDF (962/1453 Pages) Renesas Technology Corp – Series of Microcomputers (MCUs: microcomputer units)

P1 bit. Erase mode for addresses H'00000 to H'3FFFF is entered by setting SWE1 bit to 1 when
FWE = 1, then setting the ESU1 bit, and finally setting the E1 bit. FLMCR1 is initialized by a
power-on reset, and in hardware standby mode and software standby mode. Its initial value is H'80
when a high level is input to the FWE pin, and H'00 when a low level is input. When on-chip flash
memory is disabled, a read will return H'00, and writes are invalid.
Writes are enabled only in the following cases: Writes to bit SWE1 of FLMCR1 enabled when
FWE = 1, to bits ESU1, PSU1, EV1, and PV1 when FWE = 1 and SWE1 = 1, to bit E1 when
FWE = 1, SWE1 = 1 and ESU1 = 1, and to bit P1 when FWE = 1, SWE1 = 1, and PSU1 = 1.
Bit 7—Flash Write Enable Bit (FWE): Sets hardware protection against flash memory
programming/erasing.
Bit 7
FWE
0
1
Description
When a low level is input to the FWE pin (hardware-protected state)
When a high level is input to the FWE pin
Bit 6—Software Write Enable Bit 1 (SWE1): This bit selects write and erase valid/invalid of the
flash memory. Set it when setting bits 5 to 0, bits 7 to 0 of EBR1, and bits 3 to 0 of EBR2.
Bit 6
SWE1
0
1
Description
Writes disabled
Writes enabled
[Setting condition]
When FWE = 1
(Initial value)
Bit 5—Erase Setup Bit 1 (ESU1): Prepares for a transition to erase mode. Set this bit to 1 before
setting the E1 bit in FLMCR1 to 1. Do not set the SWE1, PSU1, EV1, PV1, E1, or P1 bit at the
same time.
Bit 5
ESU1
0
1
Description
Erase setup cleared
Erase setup
[Setting condition]
When FWE = 1 and SWE1 = 1
(Initial value)
908