HD6432633 Datasheet, PDF (28/1453 Pages) Renesas Technology Corp – Series of Microcomputers (MCUs: microcomputer units)

Power
supply
pins
H8S/2633 Series
H8S/2633F-ZTAT H8S/2633
H8S/2632
H8S/2631
PV_CC = 3.0 V to 5.5 V, V_CC = PLLV_CC = 3.0 V to 3.6 V
[When using A/D or D/A]
AV_CC = 3.6 V to 5.5 V, Vref = 3.6 V to AV_CC
[When not using A/D or D/A]
AV_CC = 3.3 V to 5.5 V, Vref = 3.3 V to AV_CC
2 power supply configurations, PV_CC (5 V power supply) and
V_CC (3 V power supply), PLLV_CC is 3 V power supply
H8S/2633R Series
H8S/2633RF-ZTAT
Vref = 4.5 V to AV_CC
H8S/2695
• PV_CC (5 V power supply) single power
supply configuration
• Do not connect the VCL pin to the
power supply. Instead, connect it to a
ground via a 0.1 µF power supply
stabilizer capacitor (which should be
mounted close to the pin).
• Do not connect the V_CC power supply
to the VCL pin.
• Note that the VCL pin is located in the
same position as the V_CC pin on the
older H8S/2633 Series and
H8S/2633F.
External
capacitor
0.1 µF
VCL (pin 11: FP128B)
(pin 7: TFP120)
V_SS (pin 9: FP128B)
(pin 5: TFP120)
EXTAL V_IH: V_CC × 0.8 V to V_CC + 0.3 V
input level _{VIL: –0.3 V to VCC × 0.2 V}
(V_CC = 3.0 V to 3.6 V)
Interrupt External interrupts: NMLIRQ7 to IRQ0
sources Internal interrupts: 72 sources
32 kHz Yes (subactive mode, subsleep mode, and watch mode supported)
oscillator
Method of
fixing OSC
pin when
32 kHz
oscillator
not used
OSC1
OSC2
V_CC power supply
Open
• There is no PLLV_CC power supply pin.
V_IH: PV_CC × 0.8 V to PV_CC + 0.3 V
V_IL: –0.3 V to PV_CC × 0.2 V
(PV_CC = 4.5 V to 5.5 V)
External interrupts:
NMLIRQ7 to IRQ0
Internal interrupts:
49 sources
No (subactive
mode, subsleep
mode, and watch
mode not
supported)
OSC1
OSC2
No 32 kHz
oscillator.
GND
The HD6432695 is
Open ^{the HD6432633}
Series. The pins
corresponding to
OSC1 and OSC2 in
the HD64F2633 are
NC pins in the
HD6432695.