HD6432633 Datasheet, PDF (217/1453 Pages) Renesas Technology Corp – Series of Microcomputers (MCUs: microcomputer units)

6.3.7 Additional Notes
(1) When a PC break is set for an instruction fetch at the address following a BSR, JSR, JMP,
TRAPA, RTE, or RTS instruction:
Even if the instruction at the address following a BSR, JSR, JMP, TRAPA, RTE, or RTS
instruction is fetched, it is not executed, and so a PC break interrupt is not generated by the
instruction fetch at the next address.
(2) When the I bit is set by an LDC, ANDC, ORC, or XORC instruction, a PC break interrupt
becomes valid two states after the end of the executing instruction. If a PC break interrupt is
set for the instruction following one of these instructions, since interrupts, including NMI, are
disabled for a 3-state period in the case of LDC, ANDC, ORC, and XORC, the next instruction
is always executed. For details, see section 5, Interrupt Controller.
(3) When a PC break is set for an instruction fetch at the address following a Bcc instruction:
A PC break interrupt is generated if the instruction at the next address is executed in
accordance with the branch condition, but is not generated if the instruction at the next address
is not executed.
(4) When a PC break is set for an instruction fetch at the branch destination address of a Bcc
instruction:
A PC break interrupt is generated if the instruction at the branch destination is executed in
accordance with the branch condition, but is not generated if the instruction at the branch
destination is not executed.
163