HD6432633 Datasheet, PDF (354/1453 Pages) Renesas Technology Corp – Series of Microcomputers (MCUs: microcomputer units)

In single address mode, on the other hand, transfer is performed between external space in which
either the transfer source or the transfer destination is specified by an address, and an external
device for which selection is performed by means of the DACK strobe, without regard to the
address. Figure 8-17 shows the data bus in single address mode.
RD
HWR, LWR
A23 to A0
Address bus
(Read)
External
memory
H8S/2633
D15 to D0
(high impedance)
DACK
(Write)
External
device
Figure 8-17 Data Bus in Single Address Mode
When using the DMAC for single address mode reading, transfer is performed from external
memory to the external device, and the DACK pin functions as a write strobe for the external
device. When using the DMAC for single address mode writing, transfer is performed from the
external device to external memory, and the DACK pin functions as a read strobe for the external
device. Since there is no directional control for the external device, one or other of the above
single directions should be used.
Bus cycles in single address mode are in accordance with the settings of the bus controller for the
external memory area. On the external device side, DACK is output in synchronization with the
address strobe. For details of bus cycles, see section 8.5.11, DMAC Bus Cycles (Single Address
Mode).
Do not specify internal space for transfer addresses in single address mode.
300