HD6432633 Datasheet, PDF (455/1453 Pages) Renesas Technology Corp – Series of Microcomputers (MCUs: microcomputer units)

10A.7.3 Pin Functions
Modes 4 to 6: In modes 4 to 6, port A pins function as address outputs according to the setting of
AE3 to AE0 in PFCR; when they do not function as address outputs, the pins function as SCI I/O
pins and I/O ports.
Port A pin functions in modes 4 to 6 are shown in figure 10A-7.
Port A
PA3 (I/O) / A19 (output) / SCK2 (I/O)
PA2 (I/O) / A18 (output) / RxD2 (input)
PA1 (I/O) / A17 (output) / TxD2 (output)
PA0 (I/O) / A16 (output)
Figure 10A-7 Port A Pin Functions (Modes 4 to 6)
Mode 7: In mode 7, port A pins function as I/O ports and SCI2 I/O pins (SCK2, TxD2, and
RxD2). Input or output can be specified for each pin on an individual bit basis. Setting a PADDR
bit to 1 makes the corresponding port A pin an output port, while clearing the bit to 0 makes the
pin an input port.
Port A pin functions are shown in figure 10A-8.
Port A
PA3 (I/O) / SCK2 (I/O)
PA2 (I/O) / RxD2 (input)
PA1 (I/O) / TxD2 (output)
PA0 (I/O)
Figure 10A-8 Port A Pin Functions (Mode 7)
10A.7.4 MOS Input Pull-Up Function
Port A has a built-in MOS input pull-up function that can be controlled by software. MOS input
pull-up can be specified as on or off on an individual bit basis.
In modes 4 to 6, if a pin is in the input state in accordance with the settings in PFCR, in the SCI’s
SCMR, SMR, and SCR, and in DDR, setting the corresponding PAPCR bit to 1 turns on the MOS
input pull-up for that pin.
401