HD6432633 Datasheet, PDF (1071/1453 Pages) Renesas Technology Corp – Series of Microcomputers (MCUs: microcomputer units)

Item
Symbol Min Typ
Max
Unit Test Conditions
Port power Operating PI_CC
— 10
16
mA
supply
PV_CC = 5.0 V
current*³
Subclock
——
50
µA
operation
Standby
Watch mode
Analog
During A/D Al_CC
power supply and D/A
current
conversions
— 0.01
——
— 0.6
5.0
T_a ≤ 50°C
20
50 °C < T_a
2.0
mA V_CC = 5.0 V
Idle
Reference
current
During A/D Al_CC
and D/A
conversions
— 0.01
5.0
T_a = 25 °C
— 4.0
5.0
µA
mA AV_ref = 5.0 V
Idle
— 0.01
5.0
µA
T_a = 25 °C
RAM standby voltage*⁴
V_RAM
2.0 —
—
V
Notes: *1 If the A/D and D/A converters are not used, do not leave the AV_CC, V_ref , and AV_SS pins
open. Apply a voltage between 3.3 V to 5.5 V to the AV_CC and V_ref pins by connecting
them to PV_CC, for instance. Set V_ref ≤ AV_CC.
*2 When using P34 and P35 as output pins, set PV_CC = 3.3 V to 5.5 V.
*3 Current dissipation values are for V_IH = V_CC (EXTAL, OSC1), AV_CC (ports 4 and 9), or
PV_CC (other), and V_IL = 0 V, with all output pins unloaded and the on-chip MOS pull-up
transistors in the off state.
*4 The values are for V_RAM ≤ V_CC < 3.0 V, V_IH min = V_CC – 0.1 V, and V_IL max = 0.1 V.
*5 I_CC depends on V_CC and f as follows:
I_CC max = 1.0 (mA) + 0.93 (mA/(MHz × V)) × V_CC × f (normal operation)
I_CC max = 1.0 (mA) + 0.77 (mA/(MHz × V)) × V_CC × f (sleep mode)
*6 The FWE pin is used only in the flash memory version.
*7 AV_CC = 3.3 V to 5.5 V if the A/D and D/A converters are not used (used as I/O ports).
*8 V_ref = 3.3 V to AV_CC if the A/D and D/A converters are not used (used as I/O ports).
1017