HD6432633 Datasheet, PDF (531/1453 Pages) Renesas Technology Corp – Series of Microcomputers (MCUs: microcomputer units)

10B.7.4 MOS Input Pull-Up Function
Port A has a built-in MOS input pull-up function that can be controlled by software. MOS input
pull-up can be specified as on or off on an individual bit basis.
In modes 4 to 6, if a pin is in the input state in accordance with the settings in PFCR, in the SCI’s
SCMR, SMR, and SCR, and in DDR, setting the corresponding PAPCR bit to 1 turns on the MOS
input pull-up for that pin.
In mode 7, if a pin is in the input state in accordance with the settings in the SCI’s SCMR, SMR,
and SCR, and in DDR, setting the corresponding PAPCR bit to 1 turns on the MOS input pull-up
for that pin.
The MOS input pull-up function is in the off state after a power-on reset, and in hardware standby
mode. The prior state is retained by a manual reset or in software standby mode.
Table 10B-11 summarizes the MOS input pull-up states.
Table 10B-11 MOS Input Pull-Up States (Port A)
Pin States
Power-On Hardware
Manual
Reset
Standby Mode Reset
Software
Standby Mode
Address output or OFF
SCI output
OFF
OFF
OFF
Other than above
ON/OFF ON/OFF
Legend:
OFF : MOS input pull-up is always off.
ON/OFF : On when PADDR = 0 and PAPCR = 1; otherwise off.
In Other
Operations
OFF
ON/OFF
477