HD6432633 Datasheet, PDF (695/1453 Pages) Renesas Technology Corp – Series of Microcomputers (MCUs: microcomputer units)

13.3 Operation
13.3.1 TCNT Incrementation Timing
TCNT is incremented by input clock pulses (either internal or external).
Internal Clock: Three different internal clock signals (ø/8, ø/64, or ø/8192) divided from the
system clock (ø) can be selected, by setting bits CKS2 to CKS0 in TCR. Figure 13-2 shows the
count timing.
ø
Internal clock
Clock input
to TCNT
TCNT
N–1
N
N+1
Figure 13-2 Count Timing for Internal Clock Input
External Clock: Three incrementation methods can be selected by setting bits CKS2 to CKS0 in
TCR: at the rising edge, the falling edge, and both rising and falling edges.
Note that the external clock pulse width must be at least 1.5 states for incrementation at a single
edge, and at least 2.5 states for incrementation at both edges. The counter will not increment
correctly if the pulse width is less than these values.
Figure 13-3 shows the timing of incrementation at both edges of an external clock signal.
641