HD6432633 Datasheet, PDF (382/1453 Pages) Renesas Technology Corp – Series of Microcomputers (MCUs: microcomputer units)

Internal Interrupt after End of Transfer: When the DTE bit is cleared to 0 by the end of
transfer or an abort, the selected internal interrupt request will be sent to the CPU or DTC even if
DTA is set to 1.
Also, if internal DMAC activation has already been initiated when operation is aborted, the
transfer is executed but flag clearing is not performed for the selected internal interrupt even if
DTA is set to 1.
An internal interrupt request following the end of transfer or an abort should be handled by the
CPU as necessary.
Channel Re-Setting: To reactivate a number of channels when multiple channels are enabled, use
exclusive handling of transfer end interrupts, and perform DMABCR control bit operations
exclusively.
Note, in particular, that in cases where multiple interrupts are generated between reading and
writing of DMABCR, and a DMABCR operation is performed during new interrupt handling, the
DMABCR write data in the original interrupt handling routine will be incorrect, and the write may
invalidate the results of the operations by the multiple interrupts. Ensure that overlapping
DMABCR operations are not performed by multiple interrupts, and that there is no separation
between read and write operations by the use of a bit-manipulation instruction.
Also, when the DTE and DTME bits are cleared by the DMAC or are written with 0, they must
first be read while cleared to 0 before the CPU can write a 1 to them.
328