HD6432633 Datasheet, PDF (1319/1453 Pages) Renesas Technology Corp – Series of Microcomputers (MCUs: microcomputer units)

BCRL—Bus Control Register L
Bit
:
7
6
5
BRLE BREQOE —
Initial value :
0
0
0
R/W
: R/W R/W
—
H'FED5
Bus Controller
4
OES*
0
R/W
3
DDS*
1
R/W
2
RCTS*
0
R/W
1
WDBE
0
R/W
0
WAITE
0
R/W
OE select
0
CS3 pin used as port or as CS3 signal output.
1
When only area 2 is set as DRAM, or when
areas 2 to 5 are set as contiguous DRAM space,
the CS3 pin is used as the OE pin.
BREQO pin enable
0
BREQO output disabled. BREQO can be used as an I/O port.
1
BREQO output enabled.
Bus release enable
0
Release of external bus privileges disabled. BREQ,
BACK, and BREQO can be used as I/O ports.
1
Release of external bus privileges enabled.
DACK timing select
0
When performing DMAC single address transmission to the
DRAM space, always perform full access. The DACK signal
level changes to LOW from T_r or T₁ cycle.
1
Burst access is also available when performing DMAC single
address transmission to the DRAM space. The DACK signal
level changes to LOW from T_C1 or T₂ cycle.
Read CAS timing select
0
CAS signal output timing is the same when reading and writing.
1
When reading, the CAS signal is asserted one half cycle faster than
when writing.
Write data buffer enable
0
Do not use write data buffer function.
1
Use write data buffer function.
WAIT pin enable
0
Wait input via WAIT pin disabled. The WAIT pin can be used as an I/O port.
1
Wait input via WAIT pin enabled.
Note: * This function is not available in the H8S/2695.
1265