HD6432633 Datasheet, PDF (182/1453 Pages) Renesas Technology Corp – Series of Microcomputers (MCUs: microcomputer units)

5.2.5 IRQ Status Register (ISR)
Bit
:
Initial value :
R/W
:
7
IRQ7F
0
R/(W)*
6
IRQ6F
0
R/(W)*
5
IRQ5F
0
R/(W)*
4
IRQ4F
0
R/(W)*
3
IRQ3F
0
R/(W)*
2
IRQ2F
0
R/(W)*
1
IRQ1F
0
R/(W)*
0
IRQ0F
0
R/(W)*
Note: * Only 0 can be written, to clear the flag.
ISR is an 8-bit readable/writable register that indicates the status of IRQ7 to IRQ0 interrupt
requests.
ISR is initialized to H'00 by a reset and in hardware standby mode.
They are not initialized in software standby mode.
Bits 7 to 0—IRQ7 to IRQ0 flags (IRQ7F to IRQ0F): These bits indicate the status of IRQ7 to
IRQ0 interrupt requests.
Bit n
IRQnF Description
0
[Clearing conditions] (Initial value)
• Cleared by reading IRQnF flag when IRQnF = 1, then writing 0 to IRQnF flag
• When interrupt exception handling is executed when low-level detection is set
(IRQnSCB = IRQnSCA = 0) and IRQn input is high
• When IRQn interrupt exception handling is executed when falling, rising, or both-edge
detection is set (IRQnSCB = 1 or IRQnSCA = 1)
• When the DTC* is activated by an IRQn interrupt, and the DISEL bit in MRB of the
DTC* is cleared to 0
1
[Setting conditions]
• When IRQn input goes low when low-level detection is set (IRQnSCB = IRQnSCA =
0)
• When a falling edge occurs in IRQn input when falling edge detection is set
(IRQnSCB = 0, IRQnSCA = 1)
• When a rising edge occurs in IRQn input when rising edge detection is set
(IRQnSCB = 1, IRQnSCA = 0)
• When a falling or rising edge occurs in IRQn input when both-edge detection is set
(IRQnSCB = IRQnSCA = 1)
(n = 7 to 0)
Note: * The DTC function is not available in the H8S/2695.
128