HD6432633 Datasheet, PDF (358/1453 Pages) Renesas Technology Corp – Series of Microcomputers (MCUs: microcomputer units)

Full Address Mode (Burst Mode): Figure 8-21 shows a transfer example in which TEND output
is enabled and word-size full address mode transfer (burst mode) is performed from external 16-
bit, 2-state access space to external 16-bit, 2-state access space.
DMA
read
DMA
write
DMA
read
DMA
write
DMA
read
DMA DMA
write dead
ø
Address bus
RD
HWR
LWR
TEND
Bus release
Burst transfer
Last transfer cycle _{Bus release}
Figure 8-21 Example of Full Address Mode (Burst Mode) Transfer
In burst mode, one-byte or one-word transfers are executed consecutively until transfer ends.
In the transfer end cycle (the cycle in which the transfer counter reaches 0), a one-state DMA dead
cycle is inserted after the DMA write cycle.
If a request from another higher-priority channel is generated after burst transfer starts, that
channel has to wait until the burst transfer ends.
If an NMI is generated while a channel designated for burst transfer is in the transfer enabled state,
the DTME bit is cleared and the channel is placed in the transfer disabled state. If burst transfer
has already been activated inside the DMAC, the bus is released on completion of a one-byte or
one-word transfer within the burst transfer, and burst transfer is suspended. If the last transfer
cycle of the burst transfer has already been activated inside the DMAC, execution continues to the
end of the transfer even if the DTME bit is cleared.
304