HD6432633 Datasheet, PDF (312/1453 Pages) Renesas Technology Corp – Series of Microcomputers (MCUs: microcomputer units)

Bit 4
DTE0A
0
1
Description
Data transfer disabled
Data transfer enabled
(Initial value)
Bits 3 to 0—Data Transfer End Interrupt Enable (DTIE): These bits enable or disable an
interrupt to the CPU or DTC when transfer ends. If the DTIE bit is set to 1 when DTE = 0, the
DMAC regards this as indicating the end of a transfer, and issues a transfer end interrupt request to
the CPU or DTC.
A transfer end interrupt can be canceled either by clearing the DTIE bit to 0 in the interrupt
handling routine, or by performing processing to continue transfer by setting the transfer counter
and address register again, and then setting the DTE bit to 1.
Bit 3—Data Transfer End Interrupt Enable 1B (DTIE1B): Enables or disables the channel 1B
transfer end interrupt.
Bit 3
DTIE1B
0
1
Description
Transfer end interrupt disabled
Transfer end interrupt enabled
(Initial value)
Bit 2—Data Transfer End Interrupt Enable 1A (DTIE1A): Enables or disables the channel 1A
transfer end interrupt.
Bit 2
DTIE1A
0
1
Description
Transfer end interrupt disabled
Transfer end interrupt enabled
(Initial value)
Bit 1—Data Transfer End Interrupt Enable 0B (DTIE0B): Enables or disables the channel 0B
transfer end interrupt.
Bit 1
DTIE0B
0
1
Description
Transfer end interrupt disabled
Transfer end interrupt enabled
(Initial value)
Bit 0—Data Transfer End Interrupt Enable 0A (DTIE0A): Enables or disables the channel 0A
transfer end interrupt.
258