HD6432633 Datasheet, PDF (870/1453 Pages) Renesas Technology Corp – Series of Microcomputers (MCUs: microcomputer units)

Bit 2
BBSY
0
1
Description
Bus is free
[Clearing condition]
When a stop condition is detected
Bus is busy
[Setting condition]
When a start condition is detected
(Initial value)
Bit 1—I²C Bus Interface Interrupt Request Flag (IRIC): Indicates that the I²C bus interface
has issued an interrupt request to the CPU. IRIC is set to 1 at the end of a data transfer, when a
slave address or general call address is detected in slave receive mode, when bus arbitration is lost
in master transmit mode, and when a stop condition is detected. IRIC is set at different times
depending on the FS bit in SAR and the WAIT bit in ICMR. See section 18.3.7, IRIC Setting
Timing and SCL Control. The conditions under which IRIC is set also differ depending on the
setting of the ACKE bit in ICCR.
IRIC is cleared by reading IRIC after it has been set to 1, then writing 0 in IRIC.
When the DTC* is used, IRIC is cleared automatically and transfer can be performed continuously
without CPU intervention.
Note: * The DTC function is not available in the H8S/2695.
816