HD6432633 Datasheet, PDF (557/1453 Pages) Renesas Technology Corp – Series of Microcomputers (MCUs: microcomputer units)

• Mode 7
Setting a PFDDR bit to 1 makes the corresponding port F pin PF6 to PF0 an output port, or in
the case of pin PF7, the ø output pin. Clearing the bit to 0 makes the pin an input port.
Port F Data Register (PFDR)
Bit
:
Initial value :
R/W
:
7
PF7DR
0
R/W
6
PF6DR
0
R/W
5
PF5DR
0
R/W
4
PF4DR
0
R/W
3
PF3DR
0
R/W
2
PF2DR
0
R/W
1
PF1DR
0
R/W
0
PF0DR
0
R/W
PFDR is an 8-bit readable/writable register that stores output data for the port F pins (PF7 to PF0).
PFDR is initialized to H'00 by a power-on reset, and in hardware standby mode. It retains its prior
state by a manual reset or in software standby mode.
Port F Register (PORTF)
Bit
:
7
6
5
4
3
2
1
0
PF7
PF6
PF5
PF4
PF3
PF2
PF1
PF0
Initial value : —*
—*
—*
—*
—*
—*
—*
—*
R/W
:
R
R
R
R
R
R
R
R
Note: * Determined by state of pins PF7 to PF0.
PORTF is an 8-bit read-only register that shows the pin states. It cannot be written to. Writing of
output data for the port F pins (PF7 to PF0) must always be performed on PFDR.
If a port F read is performed while PFDDR bits are set to 1, the PFDR values are read. If a port F
read is performed while PFDDR bits are cleared to 0, the pin states are read.
After a power-on reset and in hardware standby mode, PORTF contents are determined by the pin
states, as PFDDR and PFDR are initialized. PORTF retains its prior state by a manual reset or in
software standby mode.
503