HD6432633 Datasheet, PDF (295/1453 Pages) Renesas Technology Corp – Series of Microcomputers (MCUs: microcomputer units)

Section 8 DMA Controller (DMAC)
(This function is not available in the H8S/2695)
8.1 Overview
The H8S/2633 Series has a built-in DMA controller (DMAC) which can carry out data transfer on
up to 4 channels.
8.1.1 Features
The features of the DMAC are listed below.
• Choice of short address mode or full address mode
Short address mode
 Maximum of 4 channels can be used
 Choice of dual address mode or single address mode
 In dual address mode, one of the two addresses, transfer source and transfer destination, is
specified as 24 bits and the other as16 bits
 In single address mode, transfer source or transfer destination address only is specified as
24 bits
 In single address mode, transfer can be performed in one bus cycle
 Choice of sequential mode, idle mode, or repeat mode for dual address mode and single
address mode
Full address mode
 Maximum of 2 channels can be used
 Transfer source and transfer destination address specified as 24 bits
 Choice of normal mode or block transfer mode
• 16-Mbyte address space can be specified directly
• Byte or word can be set as the transfer unit
• Activation sources: internal interrupt, external request, auto-request (depending on transfer
mode)
 Six 16-bit timer-pulse unit (TPU) compare match/input capture interrupts
 Serial communication interface (SCI0, SCI1) transmit-data-empty interrupt, reception
complete interrupt
 A/D converter conversion end interrupt
 External request
 Auto-request
241