HD6432633 Datasheet, PDF (369/1453 Pages) Renesas Technology Corp – Series of Microcomputers (MCUs: microcomputer units)

DREQ Pin Low Level Activation Timing: Set the DTA bit for the channel for which the DREQ
pin is selected to 1.
Figure 8-32 shows an example of DREQ pin low level activated single address mode transfer.
ø
DREQ
Address bus
DACK
Bus
Bus release DMA single Bus release DMA single release
Transfer source/
destination
Transfer source/
destination
DMA control Idle
Single
Idle
Single
Idle
Channel
Request
Request clear
period
Request
Request clear
period
Minimum of
2 cycles
Minimum of
2 cycles
[1] [2] [3]
[4] [5] [6]
[7]
Acceptance resumes
Acceptance resumes
[1] Acceptance after transfer enabling; the DREQ pin low level is sampled on the rising
edge of ø, and the request is held.
[2] [5] The request is cleared at the next bus break, and activation is started in the DMAC.
[3] [6] The DMAC cycle is started.
[4] [7] Acceptance is resumed after the single cycle is completed.
(As in [1], the DREQ pin low level is sampled on the rising edge of ø, and the request is held.)
Note: In write data buffer mode, bus breaks from [2] to [7] may be hidden, and not visible.
Figure 8-32 Example of DREQ Pin Low Level Activated Single Address Mode Transfer
DREQ pin sampling is performed every cycle, with the rising edge of the next ø cycle after the
end of the DMABCR write cycle for setting the transfer enabled state as the starting point.
When the DREQ pin low level is sampled while acceptance by means of the DREQ pin is
possible, the request is held in the DMAC. Then, when activation is initiated in the DMAC, the
request is cleared. After the end of the single cycle, acceptance resumes, DREQ pin low level
sampling is performed again, and this operation is repeated until the transfer ends.
315