MC68030 Datasheet, PDF (223/602 Pages) Motorola, Inc – ENHANCED 32-BIT MICROPROCESSOR

Bus Operation
CONTROLLER
BREAKPOINT ACKNOWLEDGE
1) SET R/W TO READ
2) SET FUNCTION CODE TO CPU SPACE
3) PLACE CPU SPACE TYPE 0 ON A19-A16
4) PLACE BREAKPOINT NUMBER ON A4-A2
5) SET SIZE TO WORD
6) ASSERT ADDRESS STROBE (AS) AND DATA
STROBE (DS)
IF DSACKx OR STERM
1) LATCH DATA
2) NEGATE AS AND DS
3) GO TO A
IF BERR ASSERTED:
1) NEGATE AS AND DS
2) GO TO B
A
B
EXTERNAL DEVICE
1) PLACE REPLACEMENT OPCODE ON DATA
BUS
2) ASSERT DATA TRANSFER AND SIZE
ACKNOWLEDGE (DSACKx) SYNCHRONOUS
TERMINATION (STERM)
OR
1) ASSERT BUS ERRROR (BERR) TO INITIATE
EXCEPTION PROCESSING
1) PLACE LATCHED DATA IN INSTRUCTION
PIPELINE
2) CONTINUE PROCESSING
SLAVE NEGATES DSACKx, STERM OR BERR
1) INITIATE ILLEGAL INSTRUCTION PROCESSING
Figure 7-46. Breakpoint Operation Flow
7.5 BUS EXCEPTION CONTROL CYCLES
The MC68030 bus architecture requires assertion of either DSACKx or STERM from an
external device to signal that a bus cycle is complete. DSACKx, STERM, or AVEC is not
asserted if:
• The external device does not respond.
• No interrupt vector is provided.
• Various other application-dependent errors occur.
External circuitry can provide BERR when no device responds by asserting DSACKx,
STERM, or AVEC within an appropriate period of time after the processor asserts AS. This
allows the cycle to terminate and the processor to enter exception processing for the error
condition.
The MMU can also detect an internal bus error. This occurs when the processor attempts to
access an address in a protected area of memory (a user program attempts to access
supervisor data, for example) or after the MMU receives a bus error while searching the
address table for an address translation description.
MOTOROLA
MC68030 USER’S MANUAL
7-77