HD6417750 Datasheet, PDF (854/1039 Pages) Renesas Technology Corp – SuperH RISC engine

the rating of the pull-up resistor on port-pin f. Although this current has no effect on the
chip’s operation, unnecessary current will be dissipated.
The maximum frequency of TCK (TMS, TDI, TDO) is 20 MHz. Make the TCK or SH7750 Series
CPG setting so that the TCK frequency is lower than that of the SH7750 Series’ on-chip
peripheral module clock.
21.1.4 Register Configuration
Table 21.2 shows the H-UDI registers. Except for SDBPR, these registers are mapped in the
control register space and can be referenced by the CPU.
Table 21.2 H-UDI Registers
CPU Side
H-UDI Side
Name
Abbre-
P4
viation R/W Address
Area 7
Address
Access Initial
Access Initial
Size Value^*1 R/W Size Value^*1
Instruction
register
SDIR R H'FFF00000 H'1FF00000 16
H'FFFF R/W 32
H'FFFFFFFD
(Fixed
value^*2)
Data register SDDR/ R/W H'FFF00008 H'1FF00008 32/16 Unde- — —
—
H
SDDRH
fined
Data register SDDRL R/W H'FFF0000A H'1FF0000A 16
Unde- — —
—
L
fined
Bypass
SDBPR — —
—
—
Unde- R/W 1
—
register
fined
Interrupt
source
register^*4
SDINT R/W H'FFF00014 H'1FF00014 16
H'0000 W^*3 32
H'00000000
Boundary
SDBSR — —
—
—
Unde- R/W —
Undefined
scan register^*4
fined
Notes: *1 Initialized when the 7567 pin goes low or when the TAP is in the Test-Logic-Reset
state.
*2 The value read from H-UDI is fixed (H'FFFFFFFD).
*3 Using the H-UDI interrupt command, a 1 can be written to the least significant bit.
*4 SH7750R only
Rev. 6.0, 07/02, page 802 of 986