HD6417750 Datasheet, PDF (733/1039 Pages) Renesas Technology Corp – SuperH RISC engine

Bit 0—Serial Port Break Data (SPB2DT): Specifies the serial port RxD2 pin input data and
TxD2 pin output data. The TxD2 pin output condition is specified by the SPB2IO bit (see the
description of bit 1, SPB2IO, for details). When the TxD2 pin is designated as an output, the value
of the SPB2DT bit is output to the TxD2 pin. The RxD2 pin value is read from the SPB2DT bit
regardless of the value of the SPB2IO bit. The initial value of this bit after a power-on reset or
manual reset is undefined.
Bit 0: SPB2DT
0
1
Description
Input/output data is low-level
Input/output data is high-level
SCIF I/O port block diagrams are shown in figures 16.2 to 16.5.
MD8/
Mode setting
register
Reset
R
Q
D
D7
RTSIO
C
SPTRW
Reset
R
D6
QD
RTSDT
C
SPTRW
Internal data bus
SCIF
Modem control
enable signal*
signal
SPTRR
SPTRW: Write to SPTR
SPTRR: Read SPTR
Note: * The
pin function is designated as modem control by the MCE bit in SCFCR2.
Figure 16.2 MD8/5765 Pin
Rev. 6.0, 07/02, page 681 of 986