HD6417750 Datasheet, PDF (307/1039 Pages) Renesas Technology Corp – SuperH RISC engine

Bit: 15
14
13
—
—
—
Initial value: 0
0
0
R/W: R/W R/W R/W
12
11
10
9
8
— CKOEN PLL1EN PLL2EN IFC2
0
1
1
1
—
R
R/W R/W R/W R/W
Bit:
Initial value:
R/W:
7
IFC1
—
R/W
6
IFC0
—
R/W
5
BFC2
—
R/W
4
BFC1
—
R/W
3
BFC0
—
R/W
2
PFC2
—
R/W
1
PFC1
—
R/W
0
PFC0
—
R/W
Bits 15 to 12—Reserved: These bits are always read as 0, and should only be written with 0.
Bit 11—Clock Output Enable (CKOEN): Specifies whether a clock is output from the CKIO
pin or the CKIO pin is placed in the high-impedance state. When the CKIO pin goes to the high-
impedance state, operation continues at the operating frequency before this state was entered.
When the CKIO pin becomes high-impedance, it is pulled up.
Bit 11: CKOEN
Description
0
CKIO pin goes to high-impedance state (pulled up*)
1
Clock is output from CKIO pin
Note: * It is not pulled up in hardware standby mode.
(Initial value)
Bit 10—PLL Circuit 1 Enable (PLL1EN): Specifies whether PLL circuit 1 is on or off.
Bit 10: PLL1EN
0
1
Description
PLL circuit 1 is not used
PLL circuit 1 is used
(Initial value)
Bit 9—PLL Circuit 2 Enable (PLL2EN): Specifies whether PLL circuit 2 is on or off.
Bit 9: PLL2EN
0
1
Description
PLL circuit 2 is not used
PLL circuit 2 is used
(Initial value)
Rev. 6.0, 07/02, page 255 of 986