SAM4L Datasheet, PDF (940/1185 Pages) ATMEL Corporation – ATSAM ARM-based Flash MCU

34.7.17 Out-of-Touch Status Register i
Name:
OUTTCHi
Access Type:
Read-only
Offset:
0x60+4i
Reset Value:
0x00000000
ATSAM4L4/L2
31
OUTTCH31
30
OUTTCH30
29
OUTTCH29
28
OUTTCH28
27
OUTTCH27
26
OUTTCH26
25
OUTTCH25
24
OUTTCH24
23
OUTTCH23
22
OUTTCH22
21
OUTTCH21
20
OUTTCH20
19
OUTTCH19
18
OUTTCH18
17
OUTTCH17
16
OUTTCH16
15
OUTTCH15
14
OUTTCH14
13
OUTTCH13
12
OUTTCH12
11
OUTTCH11
10
OUTTCH10
9
OUTTCH9
8
OUTTCH8
7
OUTTCH7
6
OUTTCH6
5
OUTTCH5
4
OUTTCH4
3
OUTTCH3
2
OUTTCH2
1
OUTTCH1
0
OUTTCH0
• OUTTCHj: Out-of-Touch
These bits provides status when the CATB operates in DMA mode. Each block of configuration data (see Table 34-2), can
choose in the STATUSSEL field which bit in this register that should be set when an out-of-touch event is detected. A
STATUSSEL value of 0 will choose the OUTTCH0 bit in the OUTTCH0 register (i ==0 and j==0), while a STATUSSEL of 42 will
choose the OUTTCH10 bit in the OUTTCH1 register (i ==1 and j==10). Refer to the Module Configuration section for details of
the number of bits implemented in theese registers.
0: DMA configuration with STATUSSEL set to i*32+j has not registered an out-of-touch event.
1: DMA configuration with STATUSSEL set to i*32+j has registered an out-of-touch event.
42023C–SAM–02/2013
940