SAM4L Datasheet, PDF (827/1185 Pages) ATMEL Corporation – ATSAM ARM-based Flash MCU

30.9.9 Channel Status Register
Name:
SR
Access Type:
Read-only
Offset:
0x20 + n * 0x40
Reset Value:
0x00000000
ATSAM4L4/L2
31
30
29
28
27
26
25
24
-
-
-
-
-
-
-
-
23
22
21
20
19
18
17
16
-
-
-
-
-
MTIOB
MTIOA
CLKSTA
15
14
13
12
11
10
9
8
-
-
-
-
-
-
-
-
7
ETRGS
6
LDRBS
5
LDRAS
4
CPCS
3
CPBS
2
CPAS
1
LOVRS
0
COVFS
Note: Reading the Status Register will also clear the interrupt bit for the corresponding interrupts.
• MTIOB: TIOB Mirror
1: TIOB is high. If CMRn.WAVE is zero, this means that TIOB pin is high. If CMRn.WAVE is one, this means that TIOB is driven
high.
0: TIOB is low. If CMRn.WAVE is zero, this means that TIOB pin is low. If CMRn.WAVE is one, this means that TIOB is driven
low.
• MTIOA: TIOA Mirror
1: TIOA is high. If CMRn.WAVE is zero, this means that TIOA pin is high. If CMRn.WAVE is one, this means that TIOA is driven
high.
0: TIOA is low. If CMRn.WAVE is zero, this means that TIOA pin is low. If CMRn.WAVE is one, this means that TIOA is driven
low.
• CLKSTA: Clock Enabling Status
1: This bit is set when the clock is enabled.
0: This bit is cleared when the clock is disabled.
• ETRGS: External Trigger Status
1: This bit is set when an external trigger has occurred.
0: This bit is cleared when the SR register is read.
• LDRBS: RB Loading Status
1: This bit is set when an RB Load has occurred and CMRn.WAVE is zero.
0: This bit is cleared when the SR register is read.
• LDRAS: RA Loading Status
1: This bit is set when an RA Load has occurred and CMRn.WAVE is zero.
0: This bit is cleared when the SR register is read.
• CPCS: RC Compare Status
1: This bit is set when an RC Compare has occurred.
0: This bit is cleared when the SR register is read.
42023C–SAM–02/2013
827