SAM4L Datasheet, PDF (1139/1185 Pages) ATMEL Corporation – ATSAM ARM-based Flash MCU

ATSAM4L4/L2
Table 42-44. Differential mode, gain=1
Offset error drift vs temperature⁽¹⁾
Conversion range ⁽²⁾
ICMR⁽¹⁾
PSRR⁽¹⁾
DC supply current ⁽²⁾
Vin-Vip
-Vref
fvdd=1Hz, ext ADVREFP=3.0V
V_VDD=3.6V
fvdd=2MHz, ext
ADVREFP=3.0V V_VDD=3.6
VDDANA=3.6V,
ADVREFP=3.0V
VDDANA=1.6V,
ADVREFP=1.0V
see
Figure
42-5
100
50
1.2
0.6
0.04
Vref
mV/°K
V
dB
mA
1.
These values are based on simulation only. These values are not covered by test limits in production or characterization
2.
These values are based on characterization and not tested in production, and valid for an input voltage between 10% to 90% of
reference voltage.
Table 42-45. Unipolar mode, gain=1
Symbol
Parameter
Accuracy without compensation ⁽¹⁾
Accuracy after compensation⁽¹⁾
INL
Integral Non Linearity ⁽²⁾
DNL
Differential Non Linearity⁽²⁾
Gain error⁽²⁾
Gain error drift vs voltage⁽¹⁾
Gain error drift temperature⁽¹⁾
Offset error⁽²⁾
Offset error drift⁽¹⁾
Offset error drift temperature⁽¹⁾
Conversion range⁽¹⁾
ICMR⁽¹⁾
Conditions
After calibration Dynamic tests
No gain compensation
After calibration Dynamic tests
Gain compensation
After calibration
External reference
VDDANA/1.6
VDDANA/2.0
Bandgap After calibration
External reference
+ bandgap drift If using
bandgap
External reference
VDDANA/1.6
VDDANA/2.0
Bandgap After calibration
Vin-Vip
Min
-15
-50
-30
-10
-8
-15
-15
-15
-10
-4
-Vref
Typ
7
0
see
Figure
42-5
Max
11
±3
±3
±2.8
15
50
30
10
8
0.08
15
15
15
10
4
0.04
Vref
Units
ENOB
ENOB
LSBs
LSBs
mV
mV/V
mV/°K
mV
mV/V
mV/°K
V
42023C–SAM–02/2013
1139