SAM4L Datasheet, PDF (745/1185 Pages) ATMEL Corporation – ATSAM ARM-based Flash MCU

ATSAM4L4/L2
• Module is in slave receiver mode, a byte has been received and placed into the internal
shifter, but RHR is full: Discard the received byte and set SR.ORUN.
28.8.3.5
Bus Errors
If a bus error (misplaced START or STOP) condition is detected, the SR.BUSERR bit is set and
the TWIS waits for a new START condition.
28.8.4
Slave Transmitter Mode
If the TWIS matches an address in which the R/W bit in the TWI address phase transfer is set, it
will enter slave transmitter mode and set the SR.TRA bit (note that SR.TRA is set one
CLK_TWIS cycle after the relevant address match bit in the same register is set).
After the address phase, the following actions are performed:
1. If SMBus mode and PEC is used, NBYTES must be set up with the number of bytes to
transmit. This is necessary in order to know when to transmit the PEC byte. NBYTES
can also be used to count the number of bytes received if using DMA.
2. Byte to transmit depends on I²C/SMBus mode and CR.PEC:
– If in I²C mode or CR.PEC is zero or NBYTES is non-zero: The TWIS waits until THR
contains a valid data byte, possibly stretching the low period of TWCK. After THR
contains a valid data byte, the data byte is transferred to a shifter, and then
SR.TXRDY is changed to one because the THR is empty again.
– SMBus mode and CR.PEC is one: If NBYTES is zero, the generated PEC byte is
automatically transmitted instead of a data byte from THR. TWCK will not be
stretched by the TWIS.
3. The data byte in the shifter is transmitted.
4. NBYTES is updated. If CR.CUP is one, NBYTES is incremented, otherwise NBYTES is
decremented.
5. After each data byte has been transmitted, the master transmits an ACK (Acknowledge)
or NAK (Not Acknowledge) bit. If a NAK bit is received by the TWIS, the SR.NAK bit is
set. Note that this is done two CLK_TWIS cycles after TWCK has been sampled by the
TWIS to be HIGH (see Figure 28-9). The NAK indicates that the transfer is finished, and
the TWIS will wait for a STOP or REPEATED START. If an ACK bit is received, the
SR.NAK bit remains LOW. The ACK indicates that more data should be transmitted,
jump to step 2. At the end of the ACK/NAK clock cycle, the Byte Transfer Finished
(SR.BTF) bit is set. Note that this is done two CLK_TWIS cycles after TWCK has been
sampled by the TWIS to be LOW (see Figure 28-9). Also note that in the event that
SR.NAK bit is set, it must not be cleared before the SR.BTF bit is set to ensure correct
TWIS behavior.
6. If STOP is received, SR.TCOMP and SR.STO will be set.
7. If REPEATED START is received, SR.REP will be set.
The TWI transfers require the receiver to acknowledge each received data byte. During the
acknowledge clock pulse (9th pulse), the slave releases the data line (HIGH), enabling the mas-
ter to pull it down in order to generate the acknowledge. The slave polls the data line during this
clock pulse and sets the NAK bit in SR if the master does not acknowledge the data byte. A NAK
means that the master does not wish to receive additional data bytes. As with the other status
bits, an interrupt can be generated if enabled in the Interrupt Enable Register (IER).
SR.TXRDY is used as Transmit Ready for the Peripheral DMA Controller transmit channel.
42023C–SAM–02/2013
745