HD64F38602R Datasheet, PDF (360/552 Pages) Renesas Technology Corp – Renesas 16-Bit Single-Chip Microcomputer

Section 16 I²C Bus Interface 2 (IIC2)
16.4 Operation
The I²C bus interface 2 can communicate either in I²C bus mode or clock synchronous serial mode
by setting FS in SAR.
16.4.1
I²C Bus Format
Figure 16.3 shows the I²C bus formats. Figure 16.4 shows the I²C bus timing. The first frame
following a start condition always consists of 8 bits.
(a) I²C bus format (FS = 0)
S
SLA
R/W A
1
7
11
1
DATA
n
A
1
m
(b) I²C bus format (Repeated start condition, FS = 0)
S
SLA
R/W A
DATA
1
7
11
n1
A/A S
11
1
m1
A/A P
11
n: Transfer bit count
(n = 1 to 8)
m: Transfer frame count
(m ≥ 1)
SLA
R/W A
7
11
1
DATA
n2
m2
A/A P
11
n1 and n2: Transfer bit count (n1 and n2 = 1 to 8)
m1 and m2: Transfer frame count (m1 and m2 ≥ 1)
Figure 16.3 I²C Bus Formats
SDA
SCL
1-7
8
9
1-7
8
9
1-7
8
9
S
SLA R/W A
DATA
A
DATA
A
P
Figure 16.4 I²C Bus Timing
[Legend]
S: Start condition. The master device drives SDA from high to low while SCL is high.
SLA: Slave address
R/W: Indicates the direction of data transfer: from the slave device to the master device when
R/W is 1, or from the master device to the slave device when R/W is 0.
A: Acknowledge. The receive device drives SDA to low.
DATA: Transfer data
P: Stop condition. The master device drives SDA from low to high while SCL is high.
Rev. 3.00 May 15, 2007 Page 328 of 516
REJ09B0152-0300