HD64F38602R Datasheet, PDF (357/552 Pages) Renesas Technology Corp – Renesas 16-Bit Single-Chip Microcomputer

Section 16 I²C Bus Interface 2 (IIC2)
Initial
Bit Bit Name Value R/W Description
2
AL/OVE
0
R/(W)* Arbitration Lost Flag/Overrun Error Flag
This flag indicates that arbitration was lost in master
mode with the I²C bus format and that the final bit has
been received while RDRF = 1 with the clock
synchronous format.
When two or more master devices attempt to seize the
bus at nearly the same time, if the I²C bus interface
detects data differing from the data it sent, it sets AL to
1 to indicate that the bus has been taken by another
master.
[Setting conditions]
• If the internal SDA and SDA pin disagree at the rise
of SCL in master transmit mode
• When the SDA pin outputs high in master mode
while a start condition is detected
• When the final bit is received with the clock
synchronous format while RDRF = 1
[Clearing condition]
• When 0 is written in AL/OVE after reading AL/OVE
=1
1
AAS
0
R/(W)* Slave Address Recognition Flag
In slave receive mode, this flag is set to 1 if the first
frame following a start condition matches bits SVA6 to
SVA0 in SAR.
[Setting conditions]
• When the slave address is detected in slave receive
mode
• When the general call address is detected in slave
receive mode.
[Clearing condition]
• When 0 is written in AAS after reading AAS = 1
Rev. 3.00 May 15, 2007 Page 325 of 516
REJ09B0152-0300