SH7619_09 Datasheet, PDF (481/860 Pages) Renesas Technology Corp – Renesas 32-Bit RISC Microcomputer SuperHTM RISC engine Family / SH7619 Series

Section 15 Serial Communication Interface with FIFO (SCIF)
4. Sending a Break Signal
The I/O condition and level of the TxD pin are determined by the SPBIO and SPBDT bits in
the serial port register (SCSPTR). This feature can be used to send a break signal.
Until TE bit is set to 1 (enabling transmission) after initializing, TxD pin does not work.
During the period, mark status is performed by SPBDT bit. Therefore, the SPBIO and SPBDT
bits should be set to 1 (high level output).
To send a break signal during serial transmission, clear the SPBDT bit to 0 (designating low
level), then clear the TE bit to 0 (halting transmission). When the TE bit is cleared to 0, the
transmitter is initialized regardless of the current transmission state, and 0 is output from the
TxD pin.
5. Receive Data Sampling Timing and Receive Margin (Asynchronous Mode)
The SCIF operates on a base clock with a frequency of 16 times the transfer rate. In reception,
the SCIF synchronizes internally with the fall of the start bit, which it samples on the base
clock. Receive data is latched at the rising edge of the eighth base clock pulse. The timing is
shown in figure 15.24.
16 clocks
8 clocks
0 1 2 3 4 5 6 7 8 9 10 1112 1314 15 0 1 2 3 4 5 6 7 8 9 10 1112 1314 15 0 1 2 3 4 5
Base clock
–7.5 clocks
+7.5 clocks
Receive data
(RxD)
Synchronization
sampling timing
Start bit
D0
D1
Data sampling
timing
Figure 15.24 Receive Data Sampling Timing in Asynchronous Mode
Rev. 6.00 Jul. 15, 2009 Page 441 of 816
REJ09B0237-0600